- YouTuber Michael Rechtin uses 3D printing technology to create an afterburner that enhances thrust.
- The afterburner adds thermal energy to the airflow through propane combustion to increase thrust.
- The addition of a combustion chamber may introduce pressure losses, affecting thrust performance.
- Tests show the afterburner can increase thrust by up to 50%.
YouTuber Michael Rechtin has created a fully functional homemade afterburner using mostly 3D printed parts. He essentially employs an electric ducted fan (EDF) to inject propane into the exhaust, generating additional thrust. An EDF is a high-speed electric fan placed within a duct, typically used in model aircraft to simulate jet engines. Unlike traditional jet engines, EDFs do not burn fuel but are driven by an electric motor that accelerates air backward to produce thrust. For his latest project, Rechtin decided to add a combustion chamber after the EDF.
The process is theoretically quite simple.
The fan should accelerate the air through the duct as usual. After that, propane can be injected into the flowing air downstream of the fan. A certain ignition source will ignite the propane, causing the air to heat up dramatically, expanding and expelling hot gases at a far higher velocity than normal. Theoretically, this is similar to an afterburner, which should increase the thrust produced by the "engine." While the physical principles are correct, for it to be viable, the "cost" of the fuel must provide enough additional thrust to justify the investment. The basic principle of jet engines and propulsion is momentum. The faster a certain mass of air is expelled backward, the greater the forward thrust produced.
How the Afterburner Works
When propane burns, it adds thermal energy to the airflow. If the duct and nozzle can convert enough energy into additional exhaust velocity, thrust will increase. However, heating the air does not automatically mean an increase in thrust. The added combustion chamber may introduce pressure losses, turbulence, and drag, offsetting its benefits. In a "real" afterburner, the jet engine or turbojet compresses the air significantly before combustion. By the time the air reaches the afterburner, there is still enough pressure for acceleration.
On the other hand, the EDF compresses the incoming air very little, which creates two problems. The first is combustion stability; the airflow may extinguish the flame, especially if the fuel mixture is poor. The second is that without sufficient pressure (and an appropriate nozzle), much of the additional heat may be expelled without increasing thrust. Therefore, simply adding a combustion chamber after the fan does not make it an afterburner.
Test Results and Material Challenges
So, did it work? According to his video, the fan alone produced 2 pounds (9 N) of thrust. When the afterburner was activated, this figure surged to 3 pounds (13.3 N), an increase of 50%. After testing, the 3D printed parts showed noticeable burn marks but appeared to withstand the temperatures generated by combustion. Since the component is primarily made of plastic, continuing to use it could eventually cause permanent damage, especially considering that most 3D printed plastics soften at temperatures far below the combustion point of propane.
Rechtin anticipated this, and his design includes clever geometries to at least improve its chances of surviving the experiment. Nevertheless, since it is 3D printed, creating replacements is not a major concern for this YouTuber. Therefore, Rechtin plans to use metal instead of 3D printed plastic for an upgraded version of the design.
Future Prospects of 3D Printing Technology in Propulsion Systems
Rechtin's experiment showcases the potential of 3D printing technology in innovative propulsion systems, particularly in the rapid prototyping of homemade devices. Although the afterburner design faces challenges regarding combustion stability and material heat resistance, this innovative approach offers new insights for future propulsion system designs. With advancements in material technology, more efficient and durable solutions may emerge, which are significant for aviation and other applications requiring high thrust.

