Seoul National University Develops New Ferroelectric Memory Capacitor Operating at 0.6 Volts with 1 Trillion Cycles Endurance

·by Henderson·Engineering
Seoul National University Develops New Ferroelectric Memory Capacitor Operating at 0.6 Volts with 1 Trillion Cycles Endurance
Key Points
  • Seoul National University has developed a ferroelectric memory capacitor that operates at 0.6 volts.
  • The capacitor showed no hard electrical breakdown during the 1 trillion cycle test.
  • The study indicates a switching speed of up to 42 nanoseconds, with potential for sub-nanosecond switching.
  • This design may be applicable to high-density DRAM and low-power embedded memory.

A research team led by Seoul National University has developed a ferroelectric memory capacitor that switches at 0.6 volts. The study shows no hard electrical breakdown or permanent failure after 1 trillion cycles, with the findings published in Nature Communications and the university's press release. Dynamic random-access memory (DRAM) is widely used in smartphones and artificial intelligence servers, storing bits as charges in tiny capacitors. However, charges leak over time, necessitating regular refreshes, which consumes power.

Advantages of Ferroelectric Memory

In contrast, ferroelectric memory stores bits through polarization, or the electrical orientation of the material, which can persist without power, potentially reducing refresh costs. According to the press release, the material, hafnium zirconium oxide (HZO), combines two oxides already used in chip manufacturing. The challenge in creating this material is that faster switching typically requires higher voltages, which can shorten its lifespan. The research team stated that their electrode design, a metal layer sandwiched between materials, improves both speed and lifespan.

At the electrode interface, researchers altered the interface between the titanium nitride electrode and the 5 nanometer HZO thin film. They controlled the crystal orientation and surface of the titanium nitride electrode and suppressed oxidation at the boundaries, reducing voltage loss and allowing for uniform switching of the thin film. The study also noted that internal fields, usually a drawback as they can weaken stored polarization, actually help initiate switching at lower voltages. In tests reported in Nature Communications, the capacitor switched at 0.6 volts, with about 50% polarization flipping at approximately 42 nanoseconds, while at 1 volt, it was 8 nanoseconds.

Nanoseconds are one billionth of a second. In the 1 trillion cycle test, no hard electrical breakdown occurred at any voltage. According to the press release, using a standard of less than 20% polarization loss, the device endured 600 billion cycles at 0.6 volts and 1 trillion cycles at 1 volt.

Future Application Potential

The measured switching speed is significantly higher than nanoseconds. Researchers found that as the device area decreases, switching speeds tend to increase, with predictions suggesting sub-nanosecond flipping at capacitor sizes related to DRAM. This figure is inferred from measurements rather than direct measurement. The team also proposed a design called co-planar ferroelectric memory, structured similarly to a DRAM cell, containing a transistor and a capacitor. Circuit simulations from tests indicate that stored bits remain readable even after charge decay. Capacitor test arrays sharing a single electrode exhibited uniform behavior, with no significant polarization loss after cycling adjacent devices.

The press release noted that several points remain unproven. The circuit results come from simulations and array tests, not from completed memory chips. According to the paper, researchers from Samsung Electronics are co-authors, and the company partially funded this research. The researchers anticipate that this design could be applied to high-density DRAM-level memory and low-power embedded memory built in parallel with computing circuits. The paper's first author, Park Geun-hyung, plans to continue developing low-power memory devices. The research was published on October 29 in Nature Communications.

ItemSpecification
Voltage0.6 volts
Switching Speed42 nanoseconds

Technological Breakthrough of New Ferroelectric Memory Capacitor

This research demonstrates the stability and high performance of ferroelectric memory capacitors at low voltages, showcasing their potential application value in modern electronic devices. Compared to traditional DRAM, this new type of memory can reduce energy consumption and enhance performance, especially against the backdrop of increasing demand for high-density and embedded memory. As technology continues to develop, this breakthrough could have profound implications for future computing architectures, particularly in fields such as artificial intelligence and the Internet of Things.

H
About the author
Henderson